Investigating the Effect of Lane Width on the Saturated Flow Rate of the Signalized Intersections

Document Type : Original Article

Authors

1 Assistant Professor, Faculty of Engineering, Guilan University, Guilan, Iran.

2 Ph.D. candidate, Faculty of Civil Engineering, Iran University of Science and Technology, Tehran, Iran.

3 Civil Engineering and Management, Civil Engineering, Pooyesh Institute of Higher Education.

4 Department of Civil Engineering, University of Eyvanekey, Eyvanekey, Iran.

Abstract

So far, many studies have been carried out to evaluate the saturation flow rate at the entrance of the intersection, in accordance with geometric characteristics, traffic flow characteristics, and driver behavior. While, despite the difference in the above specifications, there is no study on saturation flow rate at inter-section exit and due to the difference in saturation flow rates between entrance and exit, in the case of decreasing lane numbers, decreasing lane widths and other effective factors, the importance of determining the capacity of the saturation flow rate in the exit is also important. In the present study, with the help of field data acquisition at five signalized intersections pilot in the city of Rasht, the determination and analysis of saturation flow rates using macroscopic and microscopic methods are considered, considering the width of the lane in the entrance and exit branches of the intersections. The results show that saturation flow rates in the exit branch are microscopically higher than those in the entrance branch. There is also a linear correlation between lane width and saturation flow rate in the exit branches by macroscopic method with a correlation coefficient of 0.957. Regarding the correlation coefficient of the exit branch, the lane width seems to be the main criterion in determining the flow rate, while in the entrance branch; more parameters are needed to determine the flow rates.

Keywords

Main Subjects

References

[1] Transportation Research Board. (2016). “Highway Capacity Manual”, National Research Council, Wash-ington D.C.
[2] Transportation Research Board. (2011). “75 Years of the Fundamental Diagram for Traffic Flow Theory”, Greenshields Symposium, Woods Hole, Massachusetts.
[3] Lopez-Vazquez , J. F, (1998). “Determination of Maximum Value Flow Saturation Signalized Intersections”, Master’s thesis, Faculty of Civil Engineering, Autonomous University of Nuevo Leon, Monterrey, Mexico.
[4] Rahman, M. M., Ahmed, S. N., & Hassan, T. (2005). “Comparison of saturation flow rate at signalized in-tersections in Yokohama and Dhaka”, In Proceedings of the Eastern Asia Society for Transportation Studies, 5, 959-966.
[5] Perez-Cartagena, R. I., & Tarko, A. P. (2005). “Calibration of capacity parameters for signalized intersec-tions in Indiana”, Journal of transportation engineering, 131(12), 904-911.
[6] Vien, L. L., Ibrahim, W. H. W., & Mohd, A. F. (2005). “Determination of Ideeal Saturation Flow at Signal-ized Intersections Under Malaysian Road Conditions”, Journal of Transportation Science Society of Malay-sia, 1(2005), 26-37.
[7] Shao, C. Q., Rong, J., & Liu, X. M. (2011). “Study on the saturation flow rate and its influence factors at signalized intersections in China”, Procedia-Social and Behavioral Sciences, 16, 504-514. 
[8] Alam, M. J. B., Osra, K. A., Al-Bar, H. O., & Zahran, S. Z. (2010). “Signalized intersection capacity adjust-ment factors for Makkah, Saudi Arabia”, Canadian Journal of Transportation, 4(1).
[9] Iran Statistical Center, (2011). “Official Results of Census of Populations and Houses of Iran”.
[10] Bargegol, I., Amlashi, A. T., & Gilani, V. N. M. (2016). “Estimation the Saturation Flow Rate at Far-side and Nearside Legs of Signalized Intersections–Case Study: Rasht City”, Procedia engineering, 161, 226-234.
Send comment about this article
CAPTCHA Image
Civil Infrastructure Researches
Volume 4, Issue 1 - Serial Number 6
September 2018
Pages 71-79

Files

Share

How to cite

Statistics